![]() To this slim plinth, Pro-Ject added a central gravity mass point, made from "artificial stone", placed directly underneath the main platter bearing. It's chassis was reduced to a bare minimum and instead of using a rectangular plinth, the motor, platter and tonearm base all sit in line on a single piece of low-resonance MDF "plank", rounded at both ends. The RP1 is available in three colors: Cool Grey, Titanium and white.Īustrian manufacturer Pro-Ject's entry-level Elemental turntable is designed to be as plug-and-play as possible, working almost straight out of the box without any complicated setting-up or adjustments. The anti-skate adjust slider is located under the tonearm and should be set to the same figure as the tracking weight. The tonearm comes with a factory-fitted and aligned Rega Carbon cartridge, and the correct tracking force can be achieved by sliding the counterweight to the already marked position (for 1.5g - 2.0g cartridges) on the arm. It uses a simplified version of the alloy armtube casting that was developed for Rega's highly praised RB300 tonearm, with a separate, glued-in headshell and a plainer bearing housing. The hand assembled RB101 tonearm on the RP1 is an upgraded, significantly lighter version of the RB100 used on the P1, and has a three point mounting platform. Using a manual speed change instead than an automatic mechanism eliminates speed inconsistencies and reduces wear of the drive belt. Speed change between is done manually, by removing the platter and moving the drive belt to either the 33 1/3 or 45rpm groove of the drive pulley. Using a round rubber belt, the molded sub-platter is driven by a low-vibration synchronous motor with a stepped pulley. The main bearing is made with a brass well, a small steel thrust ball and features a steel spindle pressed into a 4" sub-platter which takes the belt. The RP1's platter is made of phenolic resin, a plastic material similar to Bakelite, that improves speed stability, minimizes resonant frequencies and helps eliminate vibration. It has a plain rectangular MDF plinth with three fixed rubber feet and comes with a beautifully finished clear dust-cover which can be easily installed or removed. The multi-award winning RP1 is made in Rega's factory in Essex and is designed to achieve outstanding performance way beyond the expectations of a product at this price point. Also, it was the first model in a new generation of Rega "RP" turntables, providing far greater performance than their predecessors. Their entry-level RP1 model, introduced in 2010 is a revised version of the Rega P1 (released in 2006), with new platter material, lighter tonearm and better motor. Rega is a well known British hi-fi manufacturer and has been producing turntables since 1973. Best belt-drive turntables under $500 Rega RP1
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |